Hi guys (and girls if there are any in the forum)

I have just finished setting up a basic single LIM MD110 with BC 7.2 (Yes I know it's old, its for my test lab).  The problem I have now is that the system terminates every incoming DID number on the attendant console.  NADAP looks fine as do all the route settings, can anyone point me in the right direction to find whats missing?

Many thanks in advance.

Tim Russell
http://www.russellweb.co.uk/nortel

Hi
You can check following settings.!!
opcgs , Operator call origin group set
opcts,  Operator call type data set
RODNI Route day and night number initiate

here is some example, listing from md bc 7.2
CALENDAR DATA
VERSION=FIBC7.2A/CORR3
11:50:42
05 JUL 2002
<OPDDP:DIR=ALL;
     OPERATOR DIRECTORY DATA         
     DIR       EQU             OCUST     TYPE
     890       001-0-10-00     -         1
<OPCTP:CORG=ALL;
OPERATOR CALL TYPE DATA         
CORG     CALT  ROU     OACC   CUST      NDIR  RERNUM   CEN
 1       1      -      9       -        N     -        N
 2       2      -      9       -        N     -        N
 3       3      -      9       -        N     -        N
 7       7      1      311     -        Y     490      N
<OPCGP:CORG=ALL;
      OPERATOR CALL ORIGIN GROUP DATA
      DIR
      8
      9
      0
CORG  -
 1    1
 2    1
 3    1
 7    1
<RODNP:ROU=ALL;;
ROUTE DAY AND NIGHT NUMBER DATA
ROU        TRU         DAY             NIG             
1                      9               490             
<NADAP:NUMTYP=OC&OD;
NUMBER ANALYSIS DATA            
TYPE OF SERIES                  NUMBER SERIES                   
OPERATOR COMMON NUMBER SERIES       9
OPERATOR COM. DID. NUM. SERIES    311

Obs. nig and day settings.
!!test these...

Have tou checked NUTRP; settings? If B-number conversion isn't correct, calls could be rerouted to operator console.
You should check traffic matrix (TCMAP:CON=T;) too.
Good look!

Thanks for the answers.  I believe the problem was with the ISDN30 setup.  I have now routed the ISDN to the Lab Meridian and instigated a QSIG link between the Meridian and the Ericsson, this works fine.  I'll go back to the original setup when I can get someone to reconfigure the ISDN30 for me.

Tim Russell
http://www.russellweb.co.uk/nortel

So I've got it working now, here is the config:

ROCAP (ROCAI / ROCAE)
ROU    SEL        TRM    SERV        NODG    DIST    DISL    TRAF    SIG        BCAP
2    111000000700    5    0000030111    0    30    128    00151515    111110000030     1111

RODAP (RODAI to initiate)
ROU    TYPE    VARC        VARI        VARO        FILTER  
2    SL60    H'00000300    H'00000000    H'04010000    NO

This is for a Dutch EuroISDN30.

Tim Russell
http://www.russellweb.co.uk/nortel