Hi,
I have a Merdian Norstar Compact Plus system with 2x NTBB30AF-93 cards.
We currently have 1x BT PSTN phone line on a single number. We have 4 desk handset.
BT (TalkTalk) have installed an extra line on the same number as line 1.
If I plus a analogue telephone into the new 2nd line and dial the main PBX number all four of the desk phones ring and can answer the call. If I dial the same PBX number while the first call is still active, my analogue telephone rings. This is all good and means my lines are working.
The 1st and 2nd line are patched into a DP box and then go off to a single BT telephone socket. The first line socket has an old analogue answer phone which kicks in after about 5 rings. The second line socket has my analogue phone.
Also from the DP box a pair of wires go to the Compact+ PBX and are connected to TX202 (label on PCB)
My questions are:
1. What connector on the PCB do I need to patch the second line to
2. Is there any programming required via one of the handsets to get the 2nd line to accept incoming calls and be available for a 2nd outgoing line.
Many thanks
I have a Merdian Norstar Compact Plus system with 2x NTBB30AF-93 cards.
We currently have 1x BT PSTN phone line on a single number. We have 4 desk handset.
BT (TalkTalk) have installed an extra line on the same number as line 1.
If I plus a analogue telephone into the new 2nd line and dial the main PBX number all four of the desk phones ring and can answer the call. If I dial the same PBX number while the first call is still active, my analogue telephone rings. This is all good and means my lines are working.
The 1st and 2nd line are patched into a DP box and then go off to a single BT telephone socket. The first line socket has an old analogue answer phone which kicks in after about 5 rings. The second line socket has my analogue phone.
Also from the DP box a pair of wires go to the Compact+ PBX and are connected to TX202 (label on PCB)
My questions are:
1. What connector on the PCB do I need to patch the second line to
2. Is there any programming required via one of the handsets to get the 2nd line to accept incoming calls and be available for a 2nd outgoing line.
Many thanks
