I was asked to add an extension to a Meridian 1 system with about 400 extension capability. The new extension does not initialize using a spare phone of the same type as the rest - a M2616. It goes through a endless loop of the LCD lights flashing in sequence. Does something else have to be done to enable a port possibly? Possibly this is a SL1 - I cannot tell for sure.
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations gkittelson on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
Adding new phone to a Meridian 1 1
- Thread starter pmcook
- Start date
- Thread starter
- #3
You will have to program the TN (the port in the PBX)
You will need to do a little homework - this is a good start:
~~
Gene at GHTROUT.com
You will need to do a little homework - this is a good start:
~~
Gene at GHTROUT.com
- Thread starter
- #5
-
1
- #6
If your system does not already have a VT100 or compatible terminal connected to it, there is probably a modem. If not, and your system is wall mounted, there are probably three DB25 cables coming out of the "main" cabinet. Pick one of the unused cables and adapt it to a PC with a serial port and terminal emulation software.
Yes, you have to do everything from scratch. Nothing is programmed on a TN by default.
~~
Gene at GHTROUT.com
Yes, you have to do everything from scratch. Nothing is programmed on a TN by default.
~~
Gene at GHTROUT.com
- Thread starter
- #7
- Status
Similar threads
