I have a BCM 400 at the main location with a PRI and 3 BCM 50s at 3 other locations. I need to have the 50s to dial out the PRI at the 400. All 4 BCMs are networked and have 4 diget dial accross the Network to each other, not sure how to get the 50s to pick the PRI for outdial purposes. Any suggestions Thanks in advance
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
BCM 50 needs to dial out using the PRI on BCM 400 at another location
- Thread starter SRC1
- Start date
You need to create remote access packages and give them access to your pools/blocs; and when you create your routing table at the same place where you created your rules, create a destination code (say 8) that will be used on your 400 to access PRI.
On the 50s, build a public network using your IP trunks pointing toward the 400. Separate route, don't absorb the digits.
On the 400 remote access package which will use PRI-A (or Bloc pool) for the PRI, the 9 that you sent from the 50s will be absorbed here.
NCSS NCTS NCTE
On the 400 remote access package which will use PRI-A (or Bloc pool) for the PRI, the 9 that you sent from the 50s will be absorbed here.
NCSS NCTS NCTE
- Thread starter
- #5
- Status
Similar threads
