Ds1 loop back command

Magillicuddy · Apr 8, 2009

to test a ds1 circuit I use a loop back plug. but that is a hard loop. does avaya have a soft loop command where you can loop back to your self or out to the pstn network...

I use it a lot in the cisco world but cant seem to locate it in the avaya commands

a brief command tutorial would be greatly appreciated if it exist

thank you

DontDeleteMeAgain · Apr 8, 2009

test board XXXX XXX being the board, make sure test 138 to 142 pass

Magillicuddy · Apr 8, 2009

i will try that thanks.....i would like to be abe to send a loop up to the clec if i need to when i am on the road ...does any one know of such a command

DontDeleteMeAgain · Apr 8, 2009

I would like to know that myself, i see the loop back command but i'm not sure how it works.

mikeydidit · Apr 8, 2009

Code:

Enter DS1 board location,
 ['cpe-loopback-jack-test-begin [ number-of-bits bit-pattern ]' or
  'far-csu-loopback-test-begin' or 'one-way-span-test-begin' or
  'end-loopback/span-test' or 'inject-single-bit-error' or
  'ds1/csu-loopback-tests']

Or press CANCEL to cancel the command


Identifier command word(s) omitted; please press HELP
Command: test ds1-loop

These may help. Also for more on loop backs look for this manual.

555-025-107

"A people that values its privileges above its principles soon loses both."
- Dwight D. Eisenhower (1890-1969), Inaugural Address, January 20, 1953

For the best response to a question, read faq690-6594

Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Ds1 loop back command

Magillicuddy

IS-IT--Management

DontDeleteMeAgain

Vendor

Magillicuddy

IS-IT--Management

DontDeleteMeAgain

Vendor

mikeydidit

IS-IT--Management

Similar threads

Part and Inventory Search

Sponsor