INTELLIGENT WORK FORUMS
FOR COMPUTER PROFESSIONALS
Come Join Us!
Are you a
Computer / IT professional?
Join Tek-Tips now!
- Talk With Other Members
- Be Notified Of Responses
To Your Posts
- Keyword Search
- One-Click Access To Your
Favorite Forums
- Automated Signatures
On Your Posts
- Best Of All, It's Free!
*Tek-Tips's functionality depends on members receiving e-mail. By joining you are opting in to receive e-mail.
Partner With Us!
"Best Of Breed" Forums Add Stickiness To Your Site
(Download This Button Today!)
Feedback
"...Your site is a great idea. I should have joined your site years ago. Better late than never..."
Geography
Where in the world do Tek-Tips members come from?
|
Avaya: DEFINITY systems FAQ
|
IPSI Board TN2312AP/BP
|
IPSI Swap Procedure
Posted: 25 Aug 06 (Edited 22 Dec 07)
|
IPSI IP: ______ . ______ . ______ . ______
Subnet: ______ . ______ . ______ . ______
Gateway (if any): ______ . ______ . ______ . ______
1.Install IPSI board into Gateway/Cabinet if new install. See bottom of form if swap.
2.Configure your laptop's Ethernet port to 192.11.13.5 and 255.255.255.252
3.Connect laptop via Cross-Over Cable to Services port on front of IPSI board.
4.On your laptop, select Start, Run, and then type cmd in the space and hit enter.
5.At DOS prompt, type telnet 192.11.13.6
6.When connected, you should see an [IPSI]: command prompt.
7.Type the word ipsilogin and hit enter.
8.Type the words craft (for the user) and serv1ces (for the password). Note: the letter i in services is replaced with the number 1. You should be at the [IPADMIN]: prompt.
9.Now type set control interface [ipsi ip address] [subnet] and hit enter. Use the IPSI IP address and Subnet from above without the brackets.
10.Now type set control gateway [gateway ip] and hit enter. Use the Gateway IP from above. The customer may not have a LAN Gateway in use for the IPSIs, so this step may not be necessary.
11.Now lock the IPSI down to 100Full with auto-negotiation disabled. Type set port speed 1 100MB, type set port duplex 1 full, type set port negotiation 1 disable.
12.Type reset and hit enter, then type y and hit enter to confirm IPSI board.
13.Now log into the IPSI board again using step 4 through 8 then come back to step 14.
14.Type show control interface to make sure the IPSI board reset was successful.
15. Type show port 1 to make sure it is set for 100Full with auto-negotiation set to disable.
16.Type exit and hit enter to exit the IPSI command line interface.
17.Type exit and hit enter to close the DOS window.
If this is a replacement of an IPSI board in a IP-Connect configuration, you need to log into the IPSI (if possible) and retrieve the existing IP addresses if they are not available from the customer. You may also retrieve them from the S87XX/S8500. Write those addresses down on the form and use those to configure the new IPSI board. |
Back to Avaya: DEFINITY systems FAQ Index
Back to Avaya: DEFINITY systems Forum
|
|
 |
|
Join Tek-Tips® Today!
Join your peers on the Internet's largest technical computer professional community.
It's easy to join and it's free.
Here's Why Members Love Tek-Tips Forums:
Talk To Other Members- Notification Of Responses To Questions
- Favorite Forums One Click Access
- Keyword Search Of All Posts, And More...
Register now while it's still free!
Already a member? Close this window and log in.
Join Us Close
